Argent Data Systems OpenTracker USB Uživatelský manuál stáhnout pdf (Strana 8)

Getting Started

• Getting started is easy with the RTrak-HAB.

Connect power, VHF antenna and GPS antenna.

Install the programming software included on the RTrak-HAB User’s CD on any

computer with a 9 pin serial port. Note: Some USB>Serial adapters have been

reported to work with this software. Use at your own risk.

Ensure that power to RTrak-HAB is REMOVED.

Remove the jumper block and connect the programming cable to the RTrak-HAB’s

programming port and the computer’s serial port.

Plug power into the RTrak-HAB.

Start up the RTrak programming software: rtrak-prog.exe. You will see a window

like this:

Select the appropriate com port and click Connect.

8. If the software properly reads the RTrak-HAB, the connect window will close and

open up a configuration window containing all of the current settings.

• When you get to this point, proceed with the following page of Basic APRS

Programming instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Argent Data Systems OpenTracker USB Uživatelský manuál Strana 8